|
| |
SUPPLIES:
-
Sweetbrier Studio™ “Teddy Bear
Picnic” Mold #1015
-
Hearty® Air Dry Clay or
Paperclay®
-
3 1/2 by 4 1/4 inch wooden
plaque
-
Acrylic Paints: White, brown,
black, tan, red.
-
Instant Expressions™- Dry
transfer rub-on verses
-
E-Z Rub on transfers—KRE-288
Violets
-
Krylon Workable Fixatif
-
Double stick tape or strong
glue like E-6000®.
-
Hardware for hanging the
plaque
Molding: Step by Step polymer clay molding instructions:
Molding: Step by Step Paper Clay molding instructions:
To demold, slightly flex the mold while using your thumbs to pull the part loose
around all sides. Gently push up on the molded part from the bottom as you flex
the mold to lift or tip the part from the mold.
DIRECTIONS:
1. Mold one T-2 following manufacturers instructions. Paint the bear with
acrylic paint. Allow to dry.
 Teddy
Detail
2.
Paint the bear as shown above using acrylic paints.
3.
Paint wooden plaque with white acrylic paint and let dry.
4.
Position the verse rub-on to the front of the plaque following
manufacture’s directions.
5.
Attach violets to the upper left hand corner following
manufacturer’s directions.
6.
Spray with Krylon® Workable Fixatif and let dry.
7.
Using double stick tape or glue, affix bear to lower right hand
corner.
8.
Put hanger onto to top middle of the plaque.
Design by Sherrie Brown
An original mold from SweetBrier
Studio™
A subsidiary of Miss Martha
Originals, Inc.
P.O. Box 5038 - Glencoe, Al. 35905
Telephone 256-492-0221 - Fax 256-492-0261
|
