|
| |
SUPPLIES:
-
Sweetbrier Studio™ “Teddy Bear
Picnic” Mold #1015
-
Hearty® Air Dry Clay or
Paperclay®
-
3 1/2 inch wooden heart
-
Acrylic Paint: White, red,
brown & black.
-
16 inches white lace
-
Instant Expressions- dry
transfer rub-ons
-
Silk flowers and leaves
-
Krylon® Workable Fixatif
-
Silver Elastic cording
-
Glue: Strong glue like
E-6000®, low melt glue gun
Molding: Step by Step polymer clay molding instructions:
Molding: Step by Step Paper Clay molding instructions:
To demold, slightly flex the mold while using your thumbs to pull the part loose
around all sides. Gently push up on the molded part from the bottom as you flex
the mold to lift or tip the part from the mold.
DIRECTIONS:
1. Mold one T-5 following manufacturers instructions. Allow to dry. Paint bear
as follows: bear brown, nose & eyes black, bow red.
2. Paint the wooden heart with white acrylic paint. Set aside to dry. Spray with
the Krylon® Workable Fixatif.
3. Tie silver cording into a loop and glue the ends to the back of the heart as
shown.
4. Starting at the center top, glue lace onto the back of the heart so that the
gathers are even on the front. When you get to the bottom point, fold the lace
over a little bit and then continue up to the top.
5. Position Verse onto heart following manufacturer's directions.
6. Use glue gun to affix silk flowers and leaves.
7. Using strong glue, attach small bear at the bottom of the heart as shown.
Design by Sherrie Brown
An original mold from SweetBrier
Studio™
A subsidiary of Miss Martha
Originals, Inc.
P.O. Box 5038 - Glencoe, Al. 35905
Telephone 256-492-0221 - Fax 256-492-0261
|
